CATIA V5 CLASSES

How to use Shaft feature with Thick profile in CATIA V5?

Shaft feature is used to create a circular solid component but Shaft feature with Thick profile is used to remove material from the inner side of the circular solid component and it looks like a tube.In this article,I am going to publish about How to use Shaft feature with Thick profile in CATIA V5 in a detailed way.

The step by step procedure is to be adopted to know the use of Shaft feature with Thick profile in CATIA V5 and is as follows.

How to use Shaft feature with Thick profile in CATIA V5
How to use Shaft feature with Thick profile in CATIA V5

Procedure:

  • The procedure of Shaft feature with Thick profile is same as the Shaft feature in CATIA V5 but a few changes takes place in order to remove material.
  • When a dialogue box of Shaft feature will appears to you then there exists a thick profile with check box.
  • Click on it and provide suitable inner and outer thickness to remove a material.

The detailed explanation was presented in the video below and you can also check the related posts of it and are as follows.

You should also know about:

The detailed explanation was presented in the video below and you can also check the related posts of it and are as follows.

This is the complete explanation of usage of Shaft feature with Thick profile which is shown in a detailed manner. If you have any doubts, feel free to ask from the comments section. Please Share and Like this blog with the whole world so that it can reach to many.

Leave a Reply