CATIA V5 CLASSES

How to use Shaft feature with merge ends in CATIA V5?

Shaft feature is used to create a circular solid component but Shaft feature with merge ends is used to keep the inner circular shaft of required dimensions only but not the outer in the whole component.In this article,I will be explaining about how to use Shaft feature with merge ends in CATIA V5 in a detailed manner.

How to use Shaft feature with merge ends in CATIA V5
How to use Shaft feature with merge ends in CATIA V5

The step by step procedure is to be needed to adopt the usage of Shaft feature with merge ends in CATIA V5 and is as follows.

Procedure:

  • The procedure of Shaft feature with merge ends in CATIA V5 is same as that of Shaft feature in CATIA V5 which is discussed earlier.
  • During the process when the dialogue box arises in Shaft feature there is an option called Merge ends which is to be enabled to make the changes in the structure or component.
  • That’s it.The component will be made by the shaft feature with merge ends.

The detailed explanation was presented in the video below and you can also check the related posts of it and are as follows.

 

The detailed explanation of Shaft feature with merge ends in CATIA V5 is shown below in the form of a video.

 

This is the complete explanation of Shaft feature with merge ends in CATIA V5 which is shown in a detailed manner. If you have any doubts, feel free to ask from the comments section. Please Share and Like this blog with the whole world so that it can reach to many.

Leave a Reply