CATIA V5 CLASSES

How to use Counter bored Hole Feature in CATIA V5?

Hole Feature is used to create a hole on the surface of a structure whereas Counter bored Hole feature is used to create a hole in two regions.one is the top region and the other is bottom region. The top region Diameter must be greater than the bottom region diameter.In this article I am going to explain about about  How to use Counter bored Hole Feature in CATIA V5 in a detailed manner.

A step by step procedure is to be adopted to know about the usage of Counter bored Hole Feature in CATIA V5 and is as follows.

 

Counter bored Hole in CATIA V5
Counter bored Hole in CATIA V5

Procedure:             

To use counter bored Hole on any surface,
  • Firstly choose a plane and let it be XY Plane.
  • Now make a sketch and extrude it with the PAD feature.
  • Thus a solid component will be obtained.
  • Choose the surface on which you need to make a hole and click on Hole Feature.
  • A dialogue box opens and it consists of Extension, Type and Threaded type.


Counter bored Hole:  

          For Counter bored Hole, choose the TYPE as Counter bored and provide the dimensions such as Diameter and Depth for Top region. Choose Extension type as up to last (for instance) and provide the dimension i.e. Diameter only and say OK.

           Thus a Counter bored hole is obtained on the solid surface.
You can also read more about:
 The detailed explanation of “Counterbored Hole type” feature with suitable extension type  is shown below in the form of a video.


Leave a Reply