ANSYS APDL TUTORIALS

How to perform Static Analysis of Structural Truss System in APDL?

The main aim of  Static Analysis of Structural Truss System is used to determine the Nodal Deflections,Reaction forces,Stresses developed due to the application of forces(X-Component of stress under Deformed shape with undeformed model etc.in Y&Z Directions) inside the system etc.Here in this article,I am going to publish about how to perform Static Analysis of Structural Truss System in Ansys APDL.
The step by step procedure to perform Static Analysis of Structural Truss System in APDL is as follows.
How to perform Static Analysis of Structural Truss System in APDL
How to perform Static Analysis of Structural Truss System in APDL

 Procedure to perform Static Analysis:

This can be analyzed in ANSYS Mechanical APDL 15.0 under four stages and are follows.
1.Preferences
2.Preprocessor
3.Solution
4.General Post Processor.
 
The detailed explanation of above four stages are as follows:
1.Preferences-Structural-ok.

2.Preprocessor:

  • Element Type:Add -3D Finite stn 180-ok.
  • Real Constants-Add-Link 180-ok and provide the area of truss.
  • Material Properties-Material Models-Structural-Linear-Elastic-Isotropic-Provide Young’s modulus and Poisson’s ratio.
  • Modelling-Create-Nodes-Inactive Cs-Provide the nodes according to the drawing.

The detailed explanation of performing Static Analysis of Structural Truss System in APDL with audio is shown below in the form of video.

You can also know about:

The detailed explanation of performing Static Analysis of Structural Truss System in APDL is shown below in the form of video.

This is the complete explanation of How to perform Static Analysis of Structural Truss System in APDL in a detailed manner. If you have any doubts, feel free to ask from the comments section. Please Share and Like this blog with the whole world so that it can reach to many.

Leave a Reply